Technical Guide
Red Clay Slayer
(PH >= 1) Compare to Mud May-Day • Hydrochloric Acid
Photo Gallery
pH Level
>= 1
Type
Corrosive liquid, acidic, inorganic, n.o.s. (Hydrochloric Acid)
Product Label
SDS Sheet
Usage Instructions
Product Overview
Killshot's Red Clay Slayer is the Reaper’s deep-cut concrete assassin, designed to eliminate red clay, tire tracks, rust, and mineral stains from concrete, brick, and block.
Directions For Use
- Always test on an inconspicuous area before use.
- Use an acid-resistant plastic sprayer to apply.
- For stubborn red clay or mild rust, use full strength. For lighter staining, dilute 1:1 with water.
- Work in 3’ x 5’ sections, scrubbing with a plastic bristle brush or broom to work it deep into cracks and texture.
- Allow 10–30 minutes of dwell time, depending on stain age and severity. Keep the surface wet; reapply if drying begins.
- Rinse thoroughly with a pressure washer until the runoff runs clean.
Safety Notes
- Do not mix with other products.
- Avoid using on metal, glass, or polished surfaces.
- Always rinse thoroughly and wear protective gear.