Technical Guide
Ink Assassin
(PH >=13) Compare to Taginator • Potassium Hydroxide, Morpholine, 2 Butoxyethanol
Photo Gallery
pH Level
>= 13
Type
Potassium Hydroxide, Morpholine, 2 Butoxyethanol
Product Label
Product Information
Usage Instructions
Product Overview
Killshot's Ink Assassin is a high-powered graffiti remover designed for porous masonry surfaces like brick, concrete, stucco, granite, slate, and block. It penetrates deep into masonry pores to lift paint and plaque residue, removing graffiti shadows and ghosting in all weather conditions.
Directions For Use
- Do not dilute...use full strength.
- Apply with a pump-up sprayer or stiff brush.
- Allow it to dwell for 5–10 minutes.
- Keep the surface wet during dwell...reapply if necessary.
- Rinse with high-pressure water. Hot water speeds the removal, but cold works fine too.
- For tough shadows or multiple coats of paint, repeat the process until the surface is fully restored.
- Always test on an inconspicuous area before use.
- Do not allow product to dry on the surface.
Safety Notes
- Keep out of reach of children.
- Use eye, face, and rubber glove protection when handling.
- Do not store at temperatures above 120ºF.
- Do not allow to freeze.