Efflo & Calcium Remover

💀DIRECTIONS FOR USE

Rule #1: Always add acid to water. Never water to acid.

• Pour cold water into your bucket or tank first, then add Efflo & Calcium Remover to your desired mix strength (see below). Always test on a small, out-of-the-way section before going wide.
• Pre-rinse the surface to remove loose dirt, oil, or debris.
• Lightly mist with water so it’s damp but not dripping.
• Apply the product using a pump-up or chemical sprayer.
• Let it dwell for 20 seconds to 3 minutes...the foam tells you it’s working.
• Agitate with a stiff brush or broom if needed.
• Don’t let it dry. Rinse completely with a pressure washer or hose.
• For heavy or layered deposits, repeat the process or adjust dilution strength

💀DILUTION RATIOS THAT HIT HARD

Mix strength depends on how bad the surface buildup is and how porous the material is:

• Thick Calcium / Concrete Etching: 1:1 to 1:4
• Medium Stains / Moderate Efflorescence: 1:4 to 1:8
• Light Stains / Maintenance Cleaning: 1:8 to 1:12
• Powdery or Surface Bloom: 1:12
• General Masonry Cleaning: 1:8

Coverage averages 200–400 sq. ft. per gallon on porous masonry and up to 1,200 sq. ft. on sealed or smooth surfaces. Allow the surface to dry completely before evaluating final results.