
DIABLO Brightener Slayer
(pH N/A) Oxalic Acid (powered) - Restores Woods Natural Color & Neutralizes Strippers
Photo Gallery



pH Level
N/A
Type
Oxalic Acid (powered)
Product Label Preview
Safety Data Sheet (SDS)
Usage Instructions
(pH N/A) Oxalic Acid (powered) - Restores Woods Natural Color & Neutralizes Strippers
💀PRODUCT OVERVIEW
Restore's Brightener Slayer (DIABLO) is the Reaper’s final act...a powdered Oxalic-Acid brightener that brings wood back from the dead with vivid color and deep natural glow.
Formulated for cedar, redwood, and all exterior wood surfaces, this blend erases the dull gray haze left behind after cleaning or stripping, neutralizes alkaline residues, and restores balance to the wood grain.
Use it after Restore's Meta Clean & Strip (HOT) or Restore's Stripper Slayer (FIRE) to complete the restoration and unlock the brilliance hiding beneath weathered decking.
When the job’s done, the wood doesn’t just look new...it looks Resurrected
💀DIRECTIONS FOR USE
• Mix 2 pounds per 5 gallons of water. Stir until fully dissolved.
• Apply immediately after cleaning or stripping while the wood is still damp.
• Use a pump-up or low-pressure sprayer for even coverage.
• Do not rinse. Allow the surface to dry completely to let the chemistry finish its work.
• Once dry, the wood will reveal its true tone...bright, even, and ready for stain or sealer.
⚠️ Always test in an inconspicuous area before full application. Avoid contact with metal hardware or non-target surfaces.
💀 RESTORATION THAT HITS LIKE RESURRECTION
• Neutralizes alkaline residue from strippers and cleaners.
• Restores natural wood color and grain definition.
• Enhances stain adhesion and color penetration.
💀BUILT FOR CONTRACTORS 🔥TESTED IN THE FIELD.
APPROVED BY #TheGrimReaperOfGrime
